Citrix Systems Network Router NETSCALER 9.3 Manuel d'utilisateur télécharger pdf (Page 103)

rpm -e NSweblog

To get more information about the NSweblog RPM file

At a command prompt, type:

rpm -qpi *.rpm

To view the installed Web server logging files

At a command prompt, type:

rpm -qpl *.rpm

NSWL Client Command Options

The following table describes the commands that you can use to configure the NSWL

client.

Table 4-3. NSWL Command Options

NSWL command Specifies

nswl -help The available NSWL help options.

nswl -addns -f <path to configuration file> The system that gathers the log

transaction data. You are prompted to

enter the IP address of the NetScaler

appliance. Enter a valid user name and

password.

nswl -verify -f <path to configuration file> Check for syntax or semantic errors in

the configuration file (for example,

log.conf).

nswl -start -f <path to configuration file> Start the NSWL client based on the

settings in the configuration file (for

example, log.conf). For Solaris and

Linux: To start Web server logging as a

background process, type the ampersand

sign (&) at the end of the command.

nswl -stop (Solaris and Linux only) Stop the NSWL client if it was started as

a background process; otherwise, use

CTRL+C to stop Web server logging.

nswl -install -f <path to configuration

file> (Windows only)

Install the NSWL client as a service in

Windows.

nswl -startservice (Windows only) Start the NSWL client by using the

settings in the configuration file (for

example, log.conf) specified in the nswl

Citrix NetScaler Administration Guide

103

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 194 195

Pas de commentaire

Citrix Systems Network Router NETSCALER 9.3 Manuel d'utilisateur Page 103